AUTOMATIC ABRASIVE STRAIGHT EDGE BEVELING MACHINES

AUTOMATIC ABRASIVE STRAIGHT EDGE BEVELING MACHINES
UKF2

Bevel Plates/Parts from
1/8 to 3-Inches Thick — Ready for Welding.

Perfect Ground Surface Finish No Re-work Required	——Does your company still torch cut and hand grind?
Bevel with Abrasive Machining	——Do you hand grind bevels?
Bevel Both Top & Bottom of Part	——Do you need to have an X prep?
No Surface Contamination	——Are your welds virtually fault free?
No Tearing on Pull Out	——Do you mechanically bevel edges?

80% less material handling Increases thruput with improved consistent quality High rates of material removal - with table speeds of 20" to 197" per minute No regrinding, no carbonization and no hardness on the edges No rolling or pulling of material UFK2 Beveling Times - Parts: 50-2" L x 2.7" W x 3/4" T in 4 minutes for the edge with a 23^o angle Ideal for robotic welding Free up space on the flame-cutting tables Low noise level 70 db, compared to hand grinding (above 90 db) and oxy fuel cutting (between 85 and 90 db) Produces 500 microinch or better finishes Minimal microstructure changes All operating steps are controlled by Siemens 7 touch panel control system Dust collection ready Other models available










Applications Agriculture & Earth Moving Plate Fabrication Ship Building Vessel Manufacturing ...Anywhere Beveling of Plate/Part Products is Required